Skylight installation is a roofing job, not a window job. It requires cutting through your roof deck sheathing, framing a structural curb between the trusses or rafters, and building a weatherproof barrier with flashing, underlayment, and sealant. Gilmer Roofing & Maintenance has been installing skylights in Gilmer for 23 years — every one leak-free.
Tubular skylights are the alternative for spaces where a full skylight isn't practical — small bathrooms, closets, interior hallways. A 10-inch or 14-inch dome on the roof captures daylight through a reflective tube that channels it to a ceiling diffuser. Smaller roof penetration, simpler flashing, and effective daylighting in spaces a traditional skylight can't reach.
Our Skylight Installation Process
Free Consultation
We assess your roof from above and inside the attic. We locate the trusses and rafters, check the roof deck sheathing condition, and identify the best skylight placement for natural light based on sun angle, room layout, and roof pitch.
Curb Construction
We cut the roof deck opening through the sheathing and shingles, then frame a structural curb between the rafters with doubled lumber. Headers distribute the load around the opening. The curb provides a solid, level base for the skylight unit.
Seal Integration
Full flashing system: ice-and-water shield base layer, step flashing and counter-flashing on all four sides, woven into the existing shingle field. Water flows over the flashing and onto the shingles below — never behind them.
Install & Insulate
Unit installed and sealed. Light shaft insulated and trimmed. We verify the seal from inside the attic — if we can see any daylight at the flashing joints, we re-seal before we leave. Your skylight is watertight and energy-efficient.
What Gilmer Customers Say
"Our neighbors recommended them and now we understand why. Meticulous attention to detail and they treated our home like it was their own."
"From the first phone call to the final walkthrough, everything was seamless. The team was courteous and efficient. Already recommended them to two friends."
"After getting several quotes, these guys stood out with their honesty and knowledge. No pressure, just straightforward advice and excellent workmanship."
Why Choose Gilmer Roofing & Maintenance for Skylight Installation?
Code Compliant
Every skylight installation meets TX building code for structural framing, energy performance, and egress requirements. Permits pulled when required.
Structural Curb Framing
We frame a proper structural curb between your rafters with doubled headers. No flimsy brackets or foam shims. The curb carries the skylight load and provides a solid base for the flashing system.
Brand Options
VELUX, Fakro, Sun-Tek — fixed, vented, and tubular models. Tempered and laminated glass. Built-in blinds and shades. We help you choose the right unit for your roof, room, and budget.
Insulated Light Shafts
Every skylight installation includes rigid foam insulation around the light shaft. Uninsulated shafts cause condensation and energy loss. We insulate, vapor-seal, and trim the interior for a finished look.